Wonderful light and tool, not to miss, well made with most features .. thanks
Skip to content
Lighting, cutting, detection, pointing and an emergency glass breaker, built for warehouse, maintenance and inspection work.
A neutral white beam with a tint deviation below 0.005, so wire colours, labels and stains read true, even at low output.
Spotlight, floodlight and mixed light, so the same tool reads a label at the end of an aisle and lights up a whole workbench.
A 365nm UV light shows up leaks and markings, and a green laser points out a target from across the room.
Glow locators give off a soft glow, so the tool is quick to spot in a toolbox, on a bench or under a car seat.

Press the blade slider and the 60mm utility blade extends to the length you need, then retracts back into the body. It handles parcels, film, tape and light material trimming.
The blade lock holds it retracted when the tool goes into a pocket or bag, and a dull blade is quick to replace with a fresh one.

On floodlight, HIGH puts out 1,800 lumens across a wide area, enough to work a container, a plant room or a car park at night.
Switch to the spotlight and the beam tightens to 12,100cd, reaching 220 metres to pick out a pallet label or a figure at the end of a long aisle.

Spotlight is for distant detail and corridor checks. Floodlight spreads even light over a bench or an open control panel. Mixed light covers near and far at once, which suits walking a site or moving stock.
Double-press and hold the M button to cycle the patterns. The UTL19 remembers your choice and applies it to LOW, MID and HIGH.

The NiteLab M515S LED holds that neutral tint (Duv below 0.005) at every brightness level, closer to daylight than the blue or green cast many work lights give.
A precision metal orange peel reflector shapes it into a beam with both range and width, and a constant current circuit keeps the output stable.

The UV light runs at 365 to 375nm with three power levels, from 200mW up to 1,350mW. It makes fluorescent traces stand out, which helps with document checks, leak detection and hygiene inspections.
At 200mW it runs for up to 15 hours, long enough for a full round of checks.

The green laser has three power levels and puts a bright, precise dot on the exact pipe, shelf or fault you mean. It's quicker than describing it over the noise of a worksite.
Press and hold the M button for instant laser, even with the white light or UV already on.

The stainless steel strike bezel carries high-hardness silicon nitride ceramic tips, built to break glass quickly if you are ever trapped in a vehicle.
It adds a real reason to keep one in the glovebox, alongside the light.

Slide forward to switch on and keep sliding to step through the brightness levels. A short press of the M button moves between white light, green laser and UV, and the tool remembers the last one you used.
Run white light or UV together with the laser, or hold the M button while sliding on for a 1-lumen ULTRALOW that's easy on night-adjusted eyes.

The built-in 1,500mAh battery tops up through a covered USB-C port in about 1 hour 15 minutes from a 5V/2A adapter. Four green indicators show the remaining charge at a press of the M button.
Runtime stretches from 1 hour 15 minutes on full floodlight to 9 hours at 80 lumens, so it lasts the working day on the lower levels.

The body is aerospace-grade aluminium with a Type III hard-anodised finish, and six high-wear parts, including the switches, blade slider and bezel, are PVD-finished stainless steel.
Rated IP67 for dust and water and tested to survive a 1 metre drop, it shrugs off a tropical downpour on site or a fall off the tailgate.

The stainless steel deep-carry clip keeps the tool low and secure on a work trouser pocket, a belt or a backpack strap while you move around site.
The glow locators contain no tritium or radioactive material. They run off a tiny UV source for about 24 months of standby, and you can switch them off.
Picking, receiving and late shifts among the racking, with one tool on the belt.
Plant rooms, ceiling voids and control panels, from routine checks to call-outs.
Night rounds, stock audits and document checks on every shift.
A bright light and a way out of a car, ready in the glovebox or the toolbox.
| MODE | OUTPUT | RUNTIME | DISTANCE | INTENSITY |
| Floodlight | ||||
| High | 1,800 lm | 1h 15min | 180 m | 8,100 cd |
| Mid | 400 lm | 2h | 80 m | 1,600 cd |
| Low | 80 lm | 9h | 30 m | 225 cd |
| Ultralow | 1 lm | 270h | 4 m | 4 cd |
| Mixed light | ||||
| High | 1,200 lm | 1h 30min | 200 m | 10,000 cd |
| Mid | 400 lm | 2h | 110 m | 3,025 cd |
| Low | 80 lm | 9h | 50 m | 625 cd |
| Spotlight | ||||
| High | 800 lm | 1h 45min | 220 m | 12,100 cd |
| Mid | 330 lm | 2h | 135 m | 4,556 cd |
| Low | 80 lm | 9h | 70 m | 1,225 cd |
| UV light | ||||
| Level 3 | 1,350 mW | 3h | - | - |
| Level 2 | 600 mW | 5h | - | - |
| Level 1 | 200 mW | 15h | - | - |
| Green laser | ||||
| Level 3 | < 5 mW | 60h | - | - |
| Level 2 | < 2 mW | 130h | - | - |
| Level 1 | < 0.39 mW | 210h | - | - |
| LED | NiteLab M515S |
| Max Output | 1,800 lumens (floodlight) |
| Max Throw | 220 m (spotlight) |
| Peak Intensity | 12,100 cd |
| Tint | Duv < 0.005 |
| UV Light | 365–375 nm, 200–1,350 mW, IEC 62471 Risk Group 1 |
| Green Laser | 510–530 nm, < 5 mW, Class 3R (IEC 60825-1) |
| Battery | Built-in 1,500mAh Li-ion |
| Charging | USB-C, approx. 1h 15min (5V/2A) |
| Blade | 60 × 19 × 0.6 mm, 50° cutting angle, replaceable |
| Body | Aerospace-grade aluminium alloy (Type III hard-anodised) and stainless steel (PVD) |
| Water Resistance | IP67 |
| Impact Resistance | 1 m |
| Dimensions | 129 × 39 × 27 mm (19 mm thick without clip and blade slider) |
| Weight | 148 g (accessories not included) |
| Manual | Download Instruction Manual (PDF) |
The blade ships separately in the box and the blade lock is engaged from the factory. Slide the blade lock switch to unlock, extend the holder, hold down the release latch and slide the blade in until it seats. Give it a gentle tug to check it's secure.
Yes, it works normally while plugged in. Fully charged, it holds for about 24 months on standby, and Nitecore recommends a top-up every six months if it sits unused.
Used as intended, yes. The UV light is rated Risk Group 1 (low risk) and the green laser is Class 3R. Never look into either or aim them at people or reflective surfaces, and keep the tool away from children. It is intended for adults aged 18 and over.

![]() |
![]() |
Try it for 60 days. If it’s not right for you, send it back.
We stand behind our gear. If you’re not happy with your purchase, just return the full package within 60 days and we’ll issue a full refund—no fuss, no forms, no hoops to jump through.
Spend $99 or more today, and we'll automatically include a limited-edition Glow-in-the-Dark Ember Shard Whistle when packing your order.
Charge it quickly under sunlight or your flashlight, and enjoy its subtle glow throughout the night—perfect for marking gear, emergency kits, or attaching to your bag.
Limited quantities. These will be swapped (at our discretion) to other gift items if shards are unavailable.
If you can't find what you are looking for, or need delivery on a specific date, WhatsApp us below.